Auto Reset Button Type S01 S02 Coil Transformer Protector Bimetal Motor Thermal Protection Switch 200C 250C
|Place of Origin:||China|
|Brand Name:||Tian Rui|
|Certification:||UL TUV CQC|
|Model Number:||S01 S02|
Payment & Shipping Terms:
|Minimum Order Quantity:||1000PCS|
|Delivery Time:||5-7 Days|
|Payment Terms:||D/P, T/T,Paypal, Western Union|
|Rated Current:||3A 6A||Rated Voltage:||24VDC 125V 250V AC|
|Contact Resistance:||<30mΩ||Operating Temperature:||60-200C|
|Connection Type:||Riveting Wire||Case:||Silver-plated-iron|
|Type:||Button Type||Bimetallic Strip:||Imported Bimetallic Strip|
6A Thermal Overload Protector,
200C Thermal Overload Protector,
3A Motor Thermal Protection Switch
Auto Reset Button Type S01 S02 Coil Transformer Protector Bimetal Motor Thermal Protection Switch
S01/S02 Button type is snap action and bimetallic thermostat. Bimetal trips off or on quickly to open or close the circuit when temperature reaches the prescribed value.
|Temperature Range and Tolerance|
(A specification for each 5 °C)
(Less than a third of operating temperature)
Operating temperature tolerance
Reset temperature tolerance
The Max tripping electrical parameters
250VAC 3A / 127VAC 6A, 12VDC 6A / 24VDC 5A.
The tolerance of action temperature:±5℃, the reset temperature according to actual
Insulation voltage: The thermal protector can should be able to withstand AC1500V,
1min or AC1800V,1s between lead wire and insulation sleeving, no breakdown
flash-over phenomenon, the leakage current should be below 1mA.
Insulation resistance: Under normal conditions, the insulation resistance between lead
wire and insulation sleeving is more than 100MΩ(The meter used is DC500V insulation
Contact resistance: The contact resistance of thermal protector should be less than
Heat resistance test: The product is placed within 150℃ environment for 96 hours;
Humidity test: The product is placed at the 40℃ environment with the relative humidity
of 95% for 48 hours.
Drop test: the product drops freely once from a height of 70cm to the ground(plastic or
Under the conditions of the rated voltage, current and power factor of 1, a heat source is
added to the product to make it move for 2000 times, which should meet the following conditions:
A: The action temperature should change within ±5℃ of the initial value;
B: The contact resistance should be less than 50mΩ;
C: No welding or shedding of electrical contacts;
D: After the product continues to be tested for 10,000 times, its action to be normal and
Small size and easy for mounting;
Low current sensitivity;
Precise temperature control.
Electrical tools, motors.
Model Definition Specification and Size
Packing Storage and Transportation
Product packing adopt sealed plastic bags, shipped carton packaging.
The product should be stored at the -5~40℃ environment with the relative humidity of
40~80% for 12 months, without changes.
Direct transportation or shipment, it should be handled carefully and avoid collision or damp.
Temperature Protection Principle
The current flows the case terminal and bimetallic strip, then the bottom board
terminals is connecting to application(such as motor and transformer etc.) in circuit, when the
application works abnormally, which causes the ambient temperature to exceed the setting
value, the thermal protector cut the power off ,when the ambient temperature will decrease and
then the protector will close again.